PRICES IN CANADIAN CURRENCY - FLAT RATE SHIPPING - PRICES IN CANADIAN CURRENCY

HP6000: 2K Primer/Sealer

HP6000


TAMCO HP-6000 White E-Coat 2k Primer/Sealer - Quart

High-performance premium quality spot, panel and overall sealer and are designed for fast-drying, and provide excellent gloss holdout and Distinctness Of Image (DOI) in any topcoat system.

HP6000 White E-Coat sealer will provide excellent adhesion to:

  • Metals
  • Plastics
  • Previously painted surfaces
  • Fill minor sand scratches
  • Provides a uniform ground coat prior to applying base-coat or single stage color.

TAMCO sealers are made from topcoat direct to metal (DTM) resins giving the HP sealer unbeatable flow and leveling. This sealer will lay out as flat as any topcoat paint, reducing orange peel while giving both a uniform color and added corrosion protection. TAMCO uses the same 2 corrosion additives that we add to our direct to metal (DTM) and direct to rust (DTR) primers.

HP6000 is both a primer and sealer, you are able to spray this over bare metal, galvanized steel and properly prepared (sanded) aluminum when a high build primer is not needed. HP6000 Primer Sealers use the same hardener as our primers.

  • Mix ratio - 4:1
  • Dries in 10-15 minutes - topcoat WET on WET or up to 1 hour.
  • sealer must sit for 4 hours or more and be sanded.
  • Application:
    • Clean painted surfaces thoroughly with mild detergent and water. For substrates other than un-primed plastic or fiberglass, wipe surface with Final-Wipe
    • Repair and primed areas as required.Finish sanding substrate with a minimum of P400 DA grit or P600 grit wet. For substrates other than plastic or fiberglass, remove sanding sludge with Final-Wipe
    • Technical Manual for procedures to prepare plastic or fiberglass parts.
    • For OEM Replacement E-Coated Parts: Clean surface thoroughly with mild detergent and water.

Pot Life 1 hour at 75°F
Mix Ratio: 4 Parts HP Series Primer to 1 Part HH-3100 Hardener
DO NOT REDUCE: In HOT weather, 5% of HR900 retarder can be used.

Additives
Accelerator: Not recommended.
Fish-Eye Eliminator: Not recommended.
Retarder: Not recommended.

Gun Setups*
Compliant Siphon Feed:1.4 mm - 1.6 mm
Gravity Feed: 1.3 mm - 1.6 mm
HVLP Gravity Feed: 1.3 mm - 1.6 mm

Customer Reviews

No reviews yet
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)


Related Items