BSI Super Thin Insta-Cure CA Glue

Super Thin Insta-Cure CA Glue has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam.

Insta-Cure CA Glue give offs a vapour that can irritate the nose and eyes, so be prepared. Thin CAs work very well on 

• 3D Print
• Balsa Wood
• Soft Wood
• Hard Wood
• Glass & Metal
• Fiberglass
• Ceramics
• Hard Plastics
• Rubber
• Laminating

• Water-Resistant
• Reinforcing

Directions:

Unscrew top from nozzle. For finer applications, use the extender tip. Insta-Cure CA is used to bond tight fitting parts. Hold the parts together (sometimes using masking tape), then apply the Insta-Cure along the joints. The CA will penetrate deep into the joints. Bonding will occur in 1-3 seconds. Excess cured CA can be removed from surfaces like ceramics by rubbing with a paper towel soaked in Un-Cure. Full strength is reached in two hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220ºF. Soak extender tip in acetone for cleaning.